Multiripping saw blades for wet wood

LM05 is designed for Multiripping. Its suitability must be checked against the material, machine and exact variant specifications.

The family is specified for Softwood, Hardwood. Material density, coating, thickness and condition can affect the resulting edge quality. For LM05, verify the selected reference within its 250–600 mm diameter and 16–32-tooth range.

The catalogue specifies Multiripping machines. Before fitting, check diameter, bore, flange or pin-hole pattern and the permitted maximum speed. For LM05, verify the selected reference within its 250–600 mm diameter and 16–32-tooth range.

The family uses Dente piano con stabilizzatori 12° tooth geometry. Refer to the technical note for the carbide grade and hook angle. For LM05, verify the selected reference within its 250–600 mm diameter and 16–32-tooth range.

There are 38 variants, with diameters from 250 to 600 mm, bores from 30 to 90 mm and tooth counts from 16 to 32. For LM05, verify the selected reference within its 250–600 mm diameter and 16–32-tooth range.

For LM05, start with the machine bore (30–90 mm) and the required diameter (250–600 mm). Then select within the available 16–32-tooth range by comparing kerf, plate thickness and any pin holes or keyways.

The correct speed for an LM05 blade depends on the selected diameter, which ranges from 250 to 600 mm, and on the machine. Never exceed the lower of the maximum RPM marked on that blade and the machine manufacturer’s limit.

A specialist can assess and resharpen the Dente piano con stabilizzatori carbide teeth used by LM05, provided the blade body is undamaged. The original geometry, angles and balance must be preserved; the number of possible services depends on the condition of the selected reference.