Wood-cutting saw blades for small table saws

FRWBC is designed for Ripping and Crosscutting. Its suitability must be checked against the material, machine and exact variant specifications.

The family is specified for Softwood, Hardwood, MDF, Chipboard, Plywood. Material density, coating, thickness and condition can affect the resulting edge quality. For FRWBC, verify the selected reference within its 190–355 mm diameter and 24–108-tooth range.

The catalogue specifies Table saws. Before fitting, check diameter, bore, flange or pin-hole pattern and the permitted maximum speed. For FRWBC, verify the selected reference within its 190–355 mm diameter and 24–108-tooth range.

The family uses ATB tooth geometry. Refer to the technical note for the carbide grade and hook angle. For FRWBC, verify the selected reference within its 190–355 mm diameter and 24–108-tooth range.

There are 33 variants, with diameters from 190 to 355 mm, bores from 25.4 to 30 mm and tooth counts from 24 to 108. For FRWBC, verify the selected reference within its 190–355 mm diameter and 24–108-tooth range.

For FRWBC, start with the machine bore (25.4–30 mm) and the required diameter (190–355 mm). Then select within the available 24–108-tooth range by comparing kerf, plate thickness and any pin holes or keyways.

The correct speed for an FRWBC blade depends on the selected diameter, which ranges from 190 to 355 mm, and on the machine. Never exceed the lower of the maximum RPM marked on that blade and the machine manufacturer’s limit.

A specialist can assess and resharpen the ATB carbide teeth used by FRWBC, provided the blade body is undamaged. The original geometry, angles and balance must be preserved; the number of possible services depends on the condition of the selected reference.