Wood-cutting saw blades for hand-held and plunge saws

FRWPI is designed for Ripping and Crosscutting. Its suitability must be checked against the material, machine and exact variant specifications.

The family is specified for Softwood, Hardwood, MDF, Chipboard, Plywood. Material density, coating, thickness and condition can affect the resulting edge quality. For FRWPI, verify the selected reference within its 120–355 mm diameter and 12–60-tooth range.

The catalogue specifies Hand-held circular saws, Plunge saws. Before fitting, check diameter, bore, flange or pin-hole pattern and the permitted maximum speed. For FRWPI, verify the selected reference within its 120–355 mm diameter and 12–60-tooth range.

The family uses ATB tooth geometry. Refer to the technical note for the carbide grade and hook angle. For FRWPI, verify the selected reference within its 120–355 mm diameter and 12–60-tooth range.

There are 80 variants, with diameters from 120 to 355 mm, bores from 16 to 30 mm and tooth counts from 12 to 60. For FRWPI, verify the selected reference within its 120–355 mm diameter and 12–60-tooth range.

For FRWPI, start with the machine bore (16–30 mm) and the required diameter (120–355 mm). Then select within the available 12–60-tooth range by comparing kerf, plate thickness and any pin holes or keyways.

The correct speed for an FRWPI blade depends on the selected diameter, which ranges from 120 to 355 mm, and on the machine. Never exceed the lower of the maximum RPM marked on that blade and the machine manufacturer’s limit.

A specialist can assess and resharpen the ATB carbide teeth used by FRWPI, provided the blade body is undamaged. The original geometry, angles and balance must be preserved; the number of possible services depends on the condition of the selected reference.